This package features all of the same design features as our 3/8" AR550 12"x20" Short Range Rifle Target but includes a thicker 1/2" AR550 target intended for high volume rifle use.
Package Contains Everything you need for one target. Just buy a 2x4 at the lumber store and you are set. Note: Drilling the 2x4 is required to mount the 2x4 plate.
This target has a tilt stop to keep it from tilting backward under rapid fire, making this one of the only FULL AUTO RATED rifle targets available.
SRRT Target - 12x20 1/2" AR550
SRRT Angled Bracket
20" 2x4 plate
Shipping Priced to the lower 48 states, using FedEx Ground.
Our short range rifle targets were designed for law enforcement agencies, gun clubs and individuals looking to shoot centerfire rifles closer than 100 yards. Our design uses an AR550 target, an angled mounting bracket and an extra large base for stability. The angle helps prevent much of the pitting common with shooting rifles closer than 100 yards. This pitting can become dangerous as it may send fragments back at the shooter. This allows the target to be used up close and at longer ranges.
The bracket is fully hidden behind the target protecting it from impacts. The bolts are rugged Grade 8, 1/2” carriage bolts. Even though they are Grade 8 they will need to be replaced periodically due to bullet impacts. If you have any questions about the testing that was performed to determine the safety of the target please feel free to contact us.
Rated to 223(3000fps MAX MV) and 308(standard 150gr ball) at 50 yards for general use. Closer use may be permitted provided they are used by law enforcement agencies and professionals under close supervision. These targets are NOT TOYS! They are designed for use by trained professionals. Improper use at these ranges can lead to serious harm. If you have any questions about use, please contact us before going to the range.
The purchaser is responsible for ensuring safe use of this product. If the target or components become damaged they MUST be replaced. Contact ShootSteel.com should you need any replacement parts.
Minor assembly is required with this product. All of our stands and hangers are designed to accept 1/2" hardware (included) which will require you to use power or hand tools to tighten. Wrench/socket size for 1/2" hardware is 3/4", adjustable wrenches may be used as well. All stands will require two tools (one to hold the nut, one to tighten the bolt), while hangers will only require a single tool as the shoulder of the carriage bolt will lock into place via the cutout on the target.